Resetting Powermax Installer Code Alarm Systems
To change the installer code, click. The old code will appear (the factory default if this is the first change): E. Resetting Powermax Installer Code For Dsc Alarms; Resetting Powermax Installer Code For Dsc System; Installer Code For Dsc Alarm; To enter programming mode, press. 8 then enter the installer code (default 5555). How Do I Reset the Installer Code on a 2Gig Go!Control?. The default installer code for the 2GIG GC2 panel is 1561. If you are unable to access the Installer Toolbox, and the default installer code is not working, you can perform a hard reset to restore the installer code to default. Is is the Vivint Sky panel or a branded 2Gig GoControl. Given the fact that the code can also entered using the physical keypad it’s numeric only (confirmed in the manual). Regarding the alarm manual (also downloaded from the website) the installer code must be at least 4 characters long. The software seems to continue working after I disconnected the computer from the RS-232 electronic board.
Resetting Powermax Installer Code Alarm App
Hi Mike,There's a way to reset by powering down, installing a jumper, then powering up. That will erase all the programming though, so you probably don't want to do that, but that is the way in if you're locked out. The default master installer code for that panel is 9999, and the default regular installer code is 8888. I'm sure ADT changes them though.
Do you want to do a 'factory default' on the NX-8 panel? If that is what
you want to do, click the following link for the manual. Go to page 8 and
follow the instructions for 'Loading Factory Defaults' in the center of the
page.
NOTE: Doing this will clear the program, requiring you to program the entire
system from scratch. Please be absolutely certain this is what you want to
do before doing so.
If all you want is to change the Download Access Code, that is stored in
Location 20. Follow the instructions for changing that value alone.
Another significant code is the 'Go To Program' code, found in location 42.
It's a 4- or 6-digit code. This is the code you use to enter programming
mode.
To change any item, enter programming as follows:
Disarm the system.
Press [*]-[8].
Enter the current 'Go To Program' code.
Press [0]-[#] to program functions of the NX-8 master control panel itself.
Enter the location number you wish to display/alter, followed by the [#]
key.
Enter the desired new data, followed by the [*] key.
After you press the [*] key the program will advance to the next segment.
Change it if needed and press [*] to scroll on.
For more detailed instructions, see page 9 of the manual I referenced above.
Regards,
Robert L Bass
>
Bass Home Electronics
The Online DIY Alarm Store
http://www.Bass-Home.com
4883 Fallcrest Circle
Sarasota, FL 34233
877-722-8900 Sales & Tech Support
941-925-9747 voice (Florida)
941-923-6238 fax
Rober...@home.com
>
'mtaylor' <t1...@bellsouth.net> wrote in message
news:3a491003.14488445@news.lig.bellsouth.net...
Comments are closed.